The Gehl 4240E skid-steer battery size is Group 31, and it uses a 12-volt electrical system. Its 750 CCA rating is average for Gehl skid-steers in this dataset.
Model4240E
BrandGehl
Voltage12 V
EquipmentSkid Steer
Voltage
12 V
Cold cranking
750 CCA
Battery size
Group 31
Battery location
See details below
How this battery compares
Compared with other Gehl skid-steer battery ratings in this dataset.
Cold cranking amps750 CCA
Average
LowAverageHigh
Low 105 CCAMedian 800 CCAHigh 950 CCA
BA
Battery specification
Model-specific replacement data
System voltage
12 V
Battery group size
Group 31
Cold cranking amps
750 CCA
RP
Replacement battery
What to match when buying
The best replacement battery for the Gehl 4240E skid steer loader is a 12-volt battery with 950 cold cranking amps (CCA), typically a group 31 battery. It's advisable to use a battery that meets these specifications to ensure optimal performance.
LC
Battery location
Where the battery is mounted
The battery on the Gehl 4240E skid steer loader is typically located under the seat or in the rear compartment of the machine. For specific battery specifications and replacement options, it's best to consult the owner's manual or contact a local Gehl dealer.
ID
Model details
Equipment identity
Brand
Gehl
Model
4240E
Equipment class
Skid-Steer Loader
HOW
How to replace the battery
Basic replacement procedure
Park on level ground, lower the lift arms/attachment, stop the engine, remove the key and isolate electrical power. Open the battery access, disconnect the negative cable first and then positive, remove the hold-down and lift out the battery. Clean the tray/terminals, install the replacement securely, connect positive first and negative last, then verify charging voltage and starting operation.
!
Bad battery symptoms
Signs the battery may be failing
Common signs are slow or no cranking, repeated clicking from the starter/solenoid, dim or flickering lights/display, electronics resetting during crank, needing frequent jump-starts, rapid self-discharge, corroded/swollen battery case, or resting voltage that quickly falls under load. Confirm cable condition and alternator output before condemning the battery.
?
What battery size fits the Gehl 4240E?
Quick answer
Group 31. Best available fitment is based on closest same-brand/model-family match (SL 4240); confirm tray dimensions, terminal layout, and serial number before ordering.
?
How many CCA does the Gehl 4240E need?
Quick answer
750 CCA. Best available fitment is based on closest same-brand/model-family match (SL 4240); an equal-or-higher CCA replacement is acceptable if the physical size and terminals match.
?
What voltage battery does the Gehl 4240E use?
Quick answer
12 volts. Skid-steer starting/charging systems for this model family use a 12 V battery system; confirm serial-specific configuration before replacement.
?
Where is the battery on the Gehl 4240E?
Quick answer
The battery on the Gehl 4240E skid steer loader is typically located under the seat or in the rear compartment of the machine. For specific battery specifications and replacement options, it's best to consult the owner's manual or contact a local Gehl dealer.
?
What is the best replacement battery for the Gehl 4240E?
Quick answer
The best replacement battery for the Gehl 4240E skid steer loader is a 12-volt battery with 950 cold cranking amps (CCA), typically a group 31 battery. It's advisable to use a battery that meets these specifications to ensure optimal performance.
Disclaimer: Battery specifications are for general reference and may vary by year, serial number or configuration. Always verify fitment and electrical requirements before purchase or installation. See the Gehl website for manufacturer information.
