The Massey Ferguson 7718 tractor cooling system capacity is 21.1 gal | 80 L, coolant type is 50/50 ethylene glycol-based coolant, and coolant change interval is every 1,000 hours.
Massey Ferguson 7718 Coolant Capacity Details
Cooling system capacity
21.1 gal | 80 L
Coolant type
50/50 ethylene glycol-based coolant
Coolant change interval
Every 1,000 hours
Coolant mixture ratio
50/50 antifreeze and water
Radiator cap pressure
7 psi | 70 kPa
Coolant Capacity Comparison Chart
Coolant Capacity Comparison
This model
21.1 gal
Average
10 gal
Low
6 gal
High
16 gal
Benchmarks use practical low, average and high coolant-capacity ranges for the row-crop tractor category. Use the exact tractor manual before buying coolant.
Massey Ferguson 7718 Extra Coolant Notes
Engine horsepower
175 hp
Engine displacement
The Massey Ferguson 7718 tractor is equipped with an AGCO Power 6.6-litre engine
Capacity note
For the Massey Ferguson 7718, the listed cooling system capacity is 21.1 gal | 80 L. Buy slightly more coolant than the exact capacity so you have enough for topping off after air burps out.
Mixture note
50/50 antifreeze and water.
Radiator cap note
The radiator cap pressure listed for the Massey Ferguson 7718 is 7 psi | 70 kPa. Do not replace it with a random cap unless the pressure rating matches.
Refill note
Refill slowly, run the tractor until warm with the heater circuit open if fitted, let it cool, then recheck the coolant level. Never remove a hot radiator cap under pressure.
Massey Ferguson 7718 Coolant FAQs
How much coolant does a Massey Ferguson 7718 take?
The Massey Ferguson 7718 takes 21.1 gal | 80 L of coolant. That is well above the normal row-crop tractor benchmark shown here, so treat it as a full cooling-system service job, not a quick top-up.
Is 21.1 gal | 80 L a lot of coolant for a Massey Ferguson 7718?
Yes. For this tractor category, 21.1 gal | 80 L is well above normal. This is the sort of refill where you want all coolant on hand before draining, because stopping halfway through the job is annoying and messy.
How many coolant jugs do I need for a Massey Ferguson 7718?
Do not underestimate this refill. A 21.1 gal | 80 L system needs about 22 one-gallon containers if you are using premixed coolant. If using concentrate at a 50/50 mix, plan on about 10.6 gal of concentrate and 10.6 gal of distilled water. In metric terms, that is roughly 16 x 5 L containers for a full premix refill.
What coolant should I use in a Massey Ferguson 7718?
The listed coolant is 50/50 ethylene glycol-based coolant. Ethylene glycol tells you the base coolant, but the additive package still matters on diesel engines, so match the manual or an approved equivalent. The listed mix is 50/50 antifreeze and water, so do not run straight water except as a short emergency move.
How much concentrate and water does a Massey Ferguson 7718 need?
With the listed 50/50 antifreeze and water mix, a full 21.1 gal | 80 L refill works out to about 10.6 gal of antifreeze concentrate and 10.6 gal of distilled water. If using premix, do not add extra water unless the product label says to.
Can I use a different radiator cap on a Massey Ferguson 7718?
The listed cap pressure is 7 psi | 70 kPa. That is a lower-pressure cap, so do not upgrade it to a higher-pressure cap just because it sounds stronger. Too much cap pressure can stress hoses, radiator seams and older seals.
Official information note
Mistakes do happen. Coolant specs can change by year, engine, market, radiator option and coolant chemistry. Check the operator manual, parts book and official masseyferguson.com website before draining, flushing or refilling the cooling system.
