Case IH 5240 Coolant Capacity (15.9 gal)

Quick answer:

The Case IH 5240 tractor cooling system capacity is 15.9 gal | 60.2 L, coolant type is extended-life OAT coolant, and coolant change interval is every 6,000 hours or 6 years.

Case IH 5240 Coolant Capacity Details

Cooling system capacity 15.9 gal | 60.2 L
Coolant type Extended-life OAT coolant
Coolant change interval Every 6,000 hours or 6 years
Radiator cap pressure 13 psi | 90 kPa

Coolant Capacity Comparison Chart

Coolant Capacity Comparison

This model

15.9 gal

Average

5.5 gal

Low

3 gal

High

9 gal

Benchmarks use practical low, average and high coolant-capacity ranges for the utility tractor category. Use the exact tractor manual before buying coolant.

Case IH 5240 Extra Coolant Notes

Engine horsepower 100 hp | 74.6 kW
Engine displacement 5.9 L | 360 cu in
Capacity note For the Case IH 5240, the listed cooling system capacity is 15.9 gal | 60.2 L. Buy slightly more coolant than the exact capacity so you have enough for topping off after air burps out.
Mixture note Use the coolant type listed above and match the antifreeze/water mix to the operator manual and local freezing conditions.
Radiator cap note The radiator cap pressure listed for the Case IH 5240 is 13 psi | 90 kPa. Do not replace it with a random cap unless the pressure rating matches.
Refill note Refill slowly, run the tractor until warm with the heater circuit open if fitted, let it cool, then recheck the coolant level. Never remove a hot radiator cap under pressure.

Case IH 5240 Coolant FAQs

How much coolant does a Case IH 5240 take?

The Case IH 5240 takes 15.9 gal | 60.2 L of coolant. That is well above the normal utility tractor benchmark shown here, so treat it as a full cooling-system service job, not a quick top-up.

Is 15.9 gal | 60.2 L a lot of coolant for a Case IH 5240?

Yes. For this tractor category, 15.9 gal | 60.2 L is well above normal. This is the sort of refill where you want all coolant on hand before draining, because stopping halfway through the job is annoying and messy.

How many coolant jugs do I need for a Case IH 5240?

Do not underestimate this refill. A 15.9 gal | 60.2 L system needs about 16 one-gallon containers if you are using premixed coolant. If using concentrate at a 50/50 mix, plan on about 8 gal of concentrate and 8 gal of distilled water. In metric terms, that is roughly 13 x 5 L containers for a full premix refill.

Can I mix coolant types in a Case IH 5240?

Because the listed coolant is extended-life OAT coolant, the clean move is to stay with the same approved chemistry. Do not casually mix it with old green conventional coolant; if the old coolant type is unknown, flush first or confirm what is already in the system.

Can I use a different radiator cap on a Case IH 5240?

The listed cap pressure is 13 psi | 90 kPa. That higher-pressure cap helps raise the boiling point, but only if the radiator neck, hoses and overflow path are in good shape. A weak cap or damaged seat can still cause coolant loss.

When should the Case IH 5240 coolant be changed?

Use whichever limit comes first for the Case IH 5240: every 6,000 hours or 6 years. Low-hour tractors can still age out on time, because corrosion protection gets weaker even when the coolant still looks clean.

Official information note

Mistakes do happen. Coolant specs can change by year, engine, market, radiator option and coolant chemistry. Check the operator manual, parts book and official caseih.com website before draining, flushing or refilling the cooling system.