The deck belt size found is 81 in (2,057 mm) long by 0.5 in (13 mm) wide. The drive belt part number found is 754-04212.
Cub Cadet Tank M60 Belt Size and Part Numbers
| Mower deck belt length | 81 in (2,057 mm) |
|---|---|
| Mower deck belt width | 0.5 in (13 mm) |
| Drive belt part number | 754-04212 |
Belt Size Comparison Chart
Belt length comparison
Belt width comparison
Cub Cadet Tank M60 Belt Notes
| Mower deck belt note | The Cub Cadet Tank M60 deck belt measurement captured here is length 81 in (2,057 mm) and width 0.5 in (13 mm). Confirm the belt against the deck tag, belt decal or parts diagram before ordering |
|---|---|
| Drive belt note | The Cub Cadet Tank M60 drive or transmission belt part number captured here is 754-04212. Treat it as partial drive-belt data if no matching width or OEM part number is shown |
| Fitment note | Belts are cheap until you buy the wrong one twice. On the Cub Cadet Tank M60, confirm belt route, old belt label and OEM part number before ordering |
Cub Cadet Tank M60 Belt Size FAQ
What should you watch when fitting a 81 in (2,057 mm) deck belt on the Cub Cadet Tank M60?
A 81 in (2,057 mm) deck belt leaves little room for sloppy routing. This is a mid-length belt run, so routing and idler position still matter more than just matching a close-looking belt. Before blaming the new belt, compare the belt path to the routing decal and make sure it sits on the correct side of each keeper
Should you buy the Cub Cadet Tank M60 belt by length only?
No. The deck belt width found is 0.5 in (13 mm). That is the common 1/2-inch belt width range. Still match the OEM number because the belt angle, fabric wrap and effective length can differ. Use length, width and OEM part number together where possible
Mistakes do happen. Belt specs can change by year, mower deck, pulley layout, serial range and regional parts catalog. Please check the operator manual, belt routing decal, old belt label and official cubcadet.com before ordering a replacement belt.
