The deck belt size found is 95 in (2,413 mm) long by 0.5 in (13 mm) wide. The drive belt part number found is 754-04060. The drive belt size found is 95 in (2,413 mm) long by 0.5 in (13 mm) wide.
Deck belt sizelength 95 in (2,413 mm) and width 0.5 in (13 mm)
Drive belt part #754-04060
Drive belt sizelength 95 in (2,413 mm) and width 0.5 in (13 mm)
Cub Cadet 1210 Belt Size and Part Numbers
Mower deck belt length
95 in (2,413 mm)
Mower deck belt width
0.5 in (13 mm)
Drive belt part number
754-04060
Drive belt length
95 in (2,413 mm)
Drive belt width
0.5 in (13 mm)
Belt Size Comparison Chart
Belt length comparison
This model
95 in
Average
110 in
Low
75 in
High
155 in
Belt width comparison
This model
0.5 in
Average
0.5 in
Low
0.38 in
High
0.75 in
Cub Cadet 1210 Belt Notes
Mower deck belt note
The Cub Cadet 1210 deck belt measurement captured here is length 95 in (2,413 mm) and width 0.5 in (13 mm). Use the listed value as a buying guide, not a blind substitute for the deck-specific parts diagram
Drive belt note
The Cub Cadet 1210 drive or transmission belt listing shows part number 754-04060, length 95 in (2,413 mm) and width 0.5 in (13 mm). This is separate from the mower deck belt
Fitment note
For the Cub Cadet 1210, use the listed specs as a buying guide, but confirm against the operator manual, parts diagram or belt label before spending money
Cub Cadet 1210 Belt Size FAQ
What should you watch when fitting a 95 in (2,413 mm) deck belt on the Cub Cadet 1210?
A 95 in (2,413 mm) deck belt leaves little room for sloppy routing. This is a longer mower belt run, so twist, idler alignment and the belt keeper positions matter. A belt can be the right length and still fail if it is routed wrong. Before blaming the new belt, compare the belt path to the routing decal and make sure it sits on the correct side of each.
Can you replace the Cub Cadet 1210 belt with the same length but different width?
The deck belt width found is 0.5 in (13 mm). That is the common 1/2-inch belt width range. Still match the OEM number because the belt angle, fabric wrap and effective length can differ. A belt with the wrong top width can ride too high or too low in the pulley even if the length looks right
Official information note
Mistakes do happen. Belt specs can change by year, mower deck, pulley layout, serial range and regional parts catalog. Please check the operator manual, belt routing decal, old belt label and official cubcadet.com before ordering a replacement belt.
