The John Deere 6M 240 tractor hydraulic pump flow is 30 GPM.
Hydraulic pump flow30 GPM
Implement flow30 GPM
Total hydraulic flow30 GPM
Hydraulic system typeclosed-center
Hydraulic fluid capacity30 gal
John Deere 6M 240 Hydraulic Flow Details
Hydraulic pump flow
30 GPM
Implement hydraulic flow
30 GPM
Total hydraulic flow
30 GPM
Hydraulic system type
closed-center
Hydraulic fluid capacity
30 gal
Hydraulic Flow Comparison Chart
Hydraulic pump flow comparison
This model
30 GPM
Average
20.7 GPM
Low
3.7 GPM
High
110 GPM
Implement hydraulic flow comparison
This model
30 GPM
Average
21.2 GPM
Low
3.7 GPM
High
110 GPM
Total hydraulic flow comparison
This model
30 GPM
Average
19.9 GPM
Low
3.7 GPM
High
55 GPM
Hydraulic fluid capacity comparison
This model
30 gal
Average
12.1 gal
Low
1.2 gal
High
55 gal
John Deere 6M 240 Extra Hydraulic Notes
Hydraulic flow note
The John Deere 6M 240’s implement flow figure is about 30 GPM, so hydraulic attachment choice should be based on flow demand, not horsepower alone.
Rear remotes / SCV note
Rear remotes / SCVs depend on the tractor’s hydraulic package and options.
For hydraulic implements, match the implement to the available hydraulic flow (30 GPM), not just the number of remotes.
Check the operator manual or hydraulic package because SCV count can change by year, market and trim package.
Hydraulic system type note
The John Deere 6M 240’s hydraulic system type is closed-center, which is built for higher-pressure hydraulic control than a basic open-center setup.
Hydraulic fluid capacity note
For maintenance, the John Deere 6M 240’s hydraulic fluid capacity matters more than flow rate because it affects oil changes, filter service and refill quantity.
Official information note
Mistakes do happen. Hydraulic flow, pump flow, implement flow, pressure, rear remote / SCV setup and fluid capacity can change by year, market, transmission, pump option, loader package and hydraulic package. Please check the operator manual and official deere.com website for official information.
